APMT1604 Condition&Solution

Face and side cutter:Its three sides both have rear Angle, sharp edge and quick cutting. Face and side cutter is standard machine tool, usually used on the horizontal milling, and used for milling groove and step.Face and side cutter:Its three sides both have rear Angle, sharp edge and quick cutting. Face and side cutter is standard machine tool, usually used on the horizontal milling, and used for milling groove and step.

第一张1.jpg

第二张2.jpg

第三张3.jpg

In actual use, the lathe is used to provide power for the face and side cutter, and the machine power output is large when the insert is cut. If the cutting force can be dispersed, the machine power output can be stable and reduce the machine power,which is beneficial to prolong the machine life.

In addition, it is difficult to adapt to complex and changeable working conditions with the limitation of single inserts.


第五张5.jpg

第四张4.jpg

The left side of the three side milling cutter stand with the right three edge milling cutter. Adaptability is stronger, a new type of milling cutter seat staggered Settings, Angle staggered, and the blade is using a special blade, cutting at the same time to participate in the number of blades will not too much, cutting force, tool stable output power, reduce peak, deceleration machine maintenance frequency, less effective about cost cutting. So it has to be widely used.

The above cutter combination uses right insert and left insert.  the order quantity of right insert  is balanced with the market, while the left

insert  is relatively tight, and high cost.

第六张.jpg